Engineering Notebook – 12/03/14

Attendance:

Jacob, Tyler, Danielle

 

Goals:  

  • Redesign ramp
  • Check all screws and nuts for any that may be loose
  • Attach ramp and test

Meeting Notes

  • Used chip box light cardboard for main section of ramp, attached servo and chain.
  • Checked all screw and nuts and added lock tight were necessary.
  • Attached ramp and tested, worked O.K.
  • Problems:
    • Will need to adjust settings in program for the low, middle and high goals, also need something to put at the end of the ramp that helps direct the balls so they don’t bounce off the top of goal.
  • Next Time:
    • Work on something to put on the front of ramp to direct the balls.

20180601_221414